You Are Browsing ‘CONTROLLERS’ Category

Posted on Mar 20 2017 - 10:08pm by piddler
Comments Off on 16 Channel Servo Controller

How to setup the Raspberry Pi to interface with multiple servos utilizing a 16 channel servo controller along with Adafruit’s Servo Driver Library. *Note – Servo Controller input voltage should be 5-6 volts instead of the suggested 9 volts PARTS: RPI 3 – 4 Amp Power Adapter – 16GB Micro SD – 16-Channel...

Posted on Feb 18 2017 - 9:16am by piddler
Comments Off on L298N Dual H-Bridge

The L298N Dual H-Bridge circuit is great for controlling motors for robotic applications. It accepts a wide range of power supply voltage, anywhere from 5V – 46V. In this guide we will show you the most basic implementation of the L298N (without speed control) with the raspberry pi to drive 4 motors in a sequential pattern. PARTS: RPI 3 – 4...